Want to become a dealer?

Email us

[INSERT_ELEMENTOR id="7878"]

Request A Car Be Added To Our Lineup

[INSERT_ELEMENTOR id="62"]

2014 - 2018 Chevy Silverado/GMC Sierra (Bucket Crew Cab)

Pre Install Cleaning

To begin your installation please make sure you cup holders and other pockets are clean. To get the liners to "stick" and stay in place they pockets must be clean. We recommend simply using a wet rag to remove previous crumbs and spills. But you may have to get more aggressive depending on the condition of your cup holders. IMPORTANT: If you have previously used a UV protectant or interior detailing cleaner in your pockets such as Armor-All or 303 Aerospace, or have just picked up from the dealership we recommend you clean you pockets with at least 50% isopropyl alcohol to remove this residue as the mats may not "stick" and may slide around. 

Installing

Now simply follow the location map at the very bottom of this page or enjoy a fun puzzle learning about all the spots in your car. To install simply drop the mat into the corresponding pocket. It is very possible you have extra pieces in your kit make sure you check the install guide. If you have any problems make sure to open the "common problems" tab below.

If you have any issues at all or just want to say hello email us at support@cupholderhero.com.

Optional Double Sided Tape
Some newer kits might include a special double sided tape. There will be regions on the install guide that might recommend using this tape. The use of the tape is optional depending on your preferences. The liners will still be removable when using the tape when installed properly. The tape should stay stuck to the liner and be removable from the car surface.
Instructions for using the double sided tape:
1. Make sure both surfaces are clean (car surface and the liner)
2. Remove one piece of tape from the white backer paper and apply it to the back of the liner. Press hard for 30 seconds.
3. Remove the 3M side of the tape and gently place the liner in the pocket. Press gently.
If you need more double sided tape please just contact us.

Post Install Cleaning

To clean our liners simply use the small tab on the liner (only located on some liners) to lift it from the car. Be careful not to spill any crumbs. Now simply shake the crumbs off and if needed you can wash it in the kitchen sink under warm water. BE CAREFUL IF YOU ARE VACUUMING YOUR POCKETS AS THEY MAY GET SUCKED UP!

Common Problems

Missing Pieces?

Please Contact Us. Support@cupholderhero.com or  click the contact us button in the lower left corner. We will send you replacements out right away

Mat Not Sitting Flat/Curled Up?

Sometimes the mats might get bent a bit in shipping and deform. They should settle down in a few weeks in your car. If they do not please place them out in the sun for a bit on a flat surface. If you still have issues just send us an email. support@cupholderhero.com

"I have extra pieces" 

This is very common. We include extra pieces to fit all trim levels of the car.

You may need to long press or right click the image to view in a new tab if your screen is too small.

HELP US BY CLICKING HERE TO WRITE A REVIEW. REVIEWS REALLY HELP OUR SMALL BUSINESS EXPAND OUR PRODUCT LINE